Extreme RC XGX 3 Instruction Manual Download Page 3

GETTING FAMILIAR WITH YOUR 2.4GHZ RADIO SYSTEM

BATTERY INSTALLATION

1) Slide back the battery cover as shown and, following the polarity 

     illustratons, insert three ‘AA’ batteries.

    
2) Slide back the battery cover after batteries are installed.

 - Use batteries of same type / brand.
 - Remove batteries from R / C if not in use.
 - Always check the battery power.  
 - Dispose of used batteries properly.

 NOTES:

(A) Steering Wheel: Turns the model left and right.
(B)Trigger: Controls acceleration and braking. Pull to accelerate, release to decelerate, and push forward to brake. Pushing forward

after the car has stopped will put the car in reverse.  
(C) Battery Case: Requires (3) ‘AA’ batteries (not included).

(1) Steering Trim: Adjusts the center trim of the steering servo, aligns wheels. 

(2) Dual / Rate Servo Throw: Adjusts the center trim of the throttle / steering servo distance. Fine tunes the R / C steering wheel. 

 

(3) Throttle Trim: Adjusts the center trim of the throttle (forward and backward) and sets idle speed.

(4) Steering Reverse: Electronically switches the direction of servo travel, reversing the backward-left / forward-right relationship 

of the steering wheel to a forward- right / backward-left relationship.

(5) Throttle Reverse: Electronically switches motor operation, reversing the pull-forward / push-reverse relationship of the throttle 

to a pull-reverse / push-forward relationship.  
(6) Power Indicator Light: Stays solid red when the R / C is turned on. R / C batteries need to be changed when both Power and

Battery Indicator Lights are flashing.

(7) Battery Indicator Light: Stays solid green when batteries are fully charged. The light starts flashing when battery power is low.

Batteries need to be changed when both Power and Battery Indicator Lights are flashing 

(8) Power switch: Turns the remote controller on and off.

B: Trigger

A: Steering wheel

C: Battery case

1: Steering trim

2: Dual / rate servo throw

3: Throttle trim

4: Steering reverse

5: Throttle reverse

6: Power indicator light
7: Battery indicator light

8: Power switch

STOP

FORWARD

BACKWARD

LEFT

RIGHT

A

B

C

o

I

PAIR

TH.REV

TH. TRIM

ST. TRIM

ST. D/R

ST.REV

R

N

R

N

1

4
6

8

3

2

5
7

2

.

4

GHz

DIGITAL PROPORTIONAL SYSTEM

3

Distributed and serviced by: Extreme RC by RSI, Ferndale, MI 48220  P: (586) 757-1336  E: Service@extremercbyrsi.com

REMOTE CONTROL

REMOTE CONTROL INTERFACE

REMOTE CONTROL

REMOTE CONTROL INTERFACE

NEW ALKALINE BATTERIES- STRONGLY RECOMMENDED 

Summary of Contents for XGX 3













Reviews: