Installing Half-Duplex to Full-Duplex Converters in a 3-Slot Modular Shelf
Refer to
Installing a Half-Duplex to Full-Duplex Converter
on page 108 for installation options for the
Half-Duplex to Full-Duplex Converter.
Before installing the converter in the 3-slot modular shelf (part no. STK-RPS-1005CH3), mount the shelf
in the rack. Follow the steps in the
3-Slot Modular Shelf Quick Reference Guide
.
To install up to three Half-Duplex to Full-Duplex Converter units in the 3-slot modular shelf, follow these
steps:
1. Attach the four rubber feet (included) to the bottom of the converter, one at each corner.
2. Set the converter on the shelf.
3. Connect the converter to its power adapter, following the instructions in
to Full-Duplex Converter to its Power Adapter
4. Secure the converter to the shelf using cable ties (included with the shelf).
Pass the ties through the holes in the shelf and secure them firmly around the converter.
5. Connect the full-duplex ports (FD1 - FD4) to the switch.
6. Connect the half-duplex ports (HD1 - HD4) to your half-duplex devices.
7. Install one or two additional Half-Duplex to Full-Duplex Converter units in the shelf, as described in
steps
Mounting a Half-Duplex to Full-Duplex Converter on a Flat Surface
Refer to
Installing a Half-Duplex to Full-Duplex Converter
on page 108 for installation options for the
Half-Duplex to Full-Duplex Converter.
To install a Half-Duplex to Full-Duplex Converter unit on a flat surface, follow these steps:
1. Attach the four rubber feet (included) to the bottom of the converter, one at each corner.
2. Set the converter on a flat, stable surface.
3. Connect the converter to its power adapter, following the instructions in
to Full-Duplex Converter to its Power Adapter
4. Connect the full-duplex ports (FD1 - FD4) to the switch.
5. Connect the half-duplex ports (HD1 - HD4) to your half-duplex devices.
Mounting a Half-Duplex to Full-Duplex Converter on a Wall
Refer to
Installing a Half-Duplex to Full-Duplex Converter
on page 108 for installation options for the
Half-Duplex to Full-Duplex Converter.
To mount a Half-Duplex to Full-Duplex Converter unit on a wall, follow these steps:
1. Drill two holes in the wall, each 4 mm (0.16 in.) in diameter.
The holes should be 10.5 cm (4.13 in.) apart so that they correspond to the locations of the holes in
the bottom of the converter.
2. Insert an anchor bolt (not provided) into each hole in the wall.
3. Place a screw (not provided) into each anchor bolt and tighten so that the screw head protrudes
slightly from the wall.
Installing Expansion Modules
Installing Half-Duplex to Full-Duplex Converters in a 3-
Slot Modular Shelf
ExtremeSwitching 5520 Series Hardware Installation Guide 109
