Upgrading Extreme Management Center Engine Software
28 of 34
Reinstalling Engine Software
Use the procedure in this chapter to reinstall the engine software, in the event a
software reinstall becomes necessary. Be aware this procedure reformats the
hard drive and reinstalls all the engine software, the operating system, and all
related Linux packages.
Connect a monitor and a USB keyboard to the engine prior to performing these
steps.
1. Download the Engine Image 64-bit upgrade file to your system.
To download an engine image:
1. Access the Extreme Portal at:
https://extremeportal.force.com/
.
2. After entering your email address and password, you are on the Support page.
3. Click the Products tab and select ExtremeManagement.
4. Click ExtremeManagement in the right-panel.
5. Select a version.
6. Download the image and extract the file to a directory on your system.
2. Insert the USB flash drive that came with the engine into the USB port on your
system and note the drive letter it is assigned.
3. Open a command prompt window and cd to the directory where you extracted the
file.
4. Type
make_disk.bat <drive letter>:
.
Note: Because the reinstall procedure reformats the drive, be sure you
have specified the correct drive letter.
5. Press [Enter].
The files are copied to the USB flash drive. When the copy is complete
you see the message:
Successfully installed into <drive letter>: Press any key
to continue.
6. Remove the USB flash drive from your system.
7. Insert the USB flash drive into a USB port on the engine (see
).
8. Boot the engine from the USB drive using either of these two methods.
Method 1:
