Cable requirements
The following table describes the cables required for ERS 3500 Series.
Category 5E or higher specification cabling should be used for 1 Gbps/1000 Mbps operation.
Required Cable
Description
RJ45 console kit
1.8m cable with DB-9 Female for PC and RJ-45 for
console port
DB-9/USB integrated console cable
1.5m cable with USB Connector for PC and DB-9 for
device console port, also included USB Driver.
Stacking cables
Stacking cables are not included and must be ordered separately for ERS 3500 Series 24-port and
48-port models.
Order code
Description
AL3518001-E6
46cm SFP direct connect stack cable
AL3518002-E6
1.5 meter SFP direct connect stack cab
AL3518003-E6
3 meter SFP direct connect stack cable
Switch installation
This section describes how to install the switch on a table or shelf, or in an equipment rack. The
installation procedure is different for ERS 3510GT / ERS 3510GT-PWR+ from the other switch
models in the series.
ERS 3510GT / ERS 3510GT-PWR+ can be installed on a table or shelf, or wall mounted. It can also
be installed in an equipment rack like the other switches in the ERS 3500 Series.
See the following procedures to install the switch:
•
Installing ERS 3500 in an equipment rack
on page 22
•
Installing ERS 3510GT or ERS 3510GT-PWR+
on page 24
Installing an ERS 3500 Series switch in an equipment rack
About this task
Install an ERS 3500 Series switch in an equipment rack using the supplied brackets. The brackets
secure the chassis and prevent it from sliding around during vibration or when inserting or extracting
transceivers.
Installing the ERS 3500 Series
December 2017
Installing Ethernet Routing Switch 3500 Series
22
