3. Using the console session, perform the following:
a. At the password prompt, type user:
admin
b. For the initial password, type:
abc123
c. Press
Enter
4. Read the configuration script paragraph.
The configuration script will walk you through configuring the following information:
•
Admin Password
•
Host Attributes Settings
•
Time Settings
•
SNMP Settings
•
Data Plane Settings
5. At the end of each session, if you enter
Yes
, the next session will begin.
If you answer
No
, the session configuration is repeated.
6. Press
ENTER
.
After the final session is applied, the
Appliance Post Installation Configuration Menu
opens.
7. Type
A
to apply settings and exit or a number for repeating the setup.
8. Connect to a port on which management access was enabled during the CLI Wizard Setup.
9. Open a web browser and type the following in the address bar:
https://
Your_Mgmt_Ipaddress:5825
.
The
Extreme Campus Controller
login screen is displayed.
10. Log in, as follows:
•
Username:
admin
•
Password:
abc123
or the password that was created when setting up the installation wizard
Note
An installation wizard is available to help configure the E2122 for new deployments. Refer
to the Extreme Campus Controller User Guide on the
for more
information.
Related Topics
Configure the Management Interface via Management Port
Configure the Management Interface via Console Port
Initial Network Connection and Configuration
18
Extreme Campus Controller™
