3
9. Middle Legs.
Lift the front back roof connectors until pins locks in to position.
12. Extend the front middle leg to desired
height.
13. Stand on the foot plate and extend back
corner legs to desired height. Repeat for
middle leg.
REFER TO SECURING YOUR MARQUEE.
11. Stand on the foot plate and extend front
corner legs to desired height.
10. Ensure protective flaps are over the truss connectors. Attach them
by looping the straps around the truss and engaging the clips, then
tighten.
3MX6M SETUP INSTRUCTIONS
Recommended procedure below. For safety reasons it is recommended that 2 persons set up any marquee.
PACK DOWN INSTRUCTIONS
Recommended procedure below. For safety reasons it is recommended that 2 persons pack down any marquee. Be sure to remove any items used
to secure the marquee to ground before packing it up.
2. Push the lower leg push buttons and fully
retract the back legs.
5. Push to release all roof connector pins and
refer to the ‘LIFT HERE’ To Take Down’ sticker on
the Marquee.
CONTINUE TO NEXT PAGE >>
1. Remove Tie-Down Straps, Steel Pins,
Sandbags or Weight Plates.
3. Push the lower leg push buttons and fully
retract the front legs.
3MX6M MARQUEE
PACK DOWN
REFER TO NEXT PAGE >>
4. Unclip the roof straps.
