Extreme Flight Legacy Aviation Muscle Bipe, Assembly Manual

Page: 6 / 29

2. Locate the control horns for the ailerons, see figure 2. Be sure to lightly sand the portion that
will insert into the precut slot as well as one side of the base plate. Now trial fit the control horn
thru the base plate, trim the base plate slot if necessary to accommodate the control horn, then
insert this into the slot (use any base plate they will fit any control horn). Now trim the covering
under the base plate, make sure you do not trim beyond the base plate or cut thru the balsa.
Remove that covering and this will allow a balsa to base plate glue joint. Once satisfied with the
dry fit, then using 30 minute epoxy put some in the slot and a light coating on the bottom of the
control horn that will go into the slot and the bottom of the base plate (the lightly sanded side)
that will mate to the exposed balsa and glue this in place on all 4 ailerons and allow to dry. See
figure 3.
Figure 2
Figure 3