11
Using a 1.5mm hex driver,
remove the set screw from the
base of each side of the landing
gear. Place a drop of blue thread
locker to the set screw and screw
back into place.
Screw landing gear back into
place.
Connect the retract unit to the
landing gear controller, and the
controller to your receiver’s
gear channel.
Note:
Make sure the polarity of
the connector is correct.
The controller needs to be
cycled to learn its position and
arm. Use your radio to open the
retract unit.
Using a 1.5mm hex driver,
remove the set screw from the
gear leg holders, one at a time,
and give a drop of blue thread
locker.