25. Assemble one end of the linkage by inserting the pull-pull cable into one of the
aluminum tubes, through the hole in the brass pull-pull fitting and back
through the aluminum crimp tube. Loop the cable back through the crimp tube a
second time and crimp with side cutters.
26. Insert the bare end of the cable into the slot in the rear of the fuselage and feed it
forward into the canopy area and make up the same type of linkage as you did previously.
Electronically center your servo. Secure the linkage at both ends with a 3mm bolt and
nylon insert lock nut. Repeat for the other side. Pull-pull cables should be crossed for this
installation on the Edge.
27. Slide both stab/elevator assemblies onto the carbon fiber mounting tube and secure
with 2 3mm bolts inserted through a washer and the mounting tabs and into the
corresponding blind nuts already installed in the fuselage. Be sure to use a drop of blue
Loctite on all bolts!!!
25
