6
Let's Begin:
1. Locate the wing panels/ailerons and horizontal stabilizers/elevators and
associated hardware bags. We will begin by hinging all of these at one time.
I strongly recommend 30 minute (or slower curing) epoxy for installing
hinges. I have found it easier to apply 3-5 drops of glue in the hinge hole and
then using a toothpick, or similar, spread the glue around the sides of the
hinge hole. Do this on just one side of the surface at a time. Before applying
any glue to the hinge itself, I highly recommend you protect
the hinge pin (pivot point) from glue. I use Vaseline. Tape will work however
it is harder to remove later. In any case apply either protectant to the center
of the hinge so glue cannot penetrate the pin. Once you have the holes lathered
with glue, apply a small amount to the hinge barbs and insert into the hinge
hole until the pin is even with the hinge line. Be sure your hinge pivots freely
and is perpendicular to the hinge line. Allow to dry then mate to the
appropriate surface (wing to
aileron/horizontal stabilizer to elevator) and allow to dry. ***PLEASE
NOTE*** there are 3 hinges that have been shortened to clear the tube
socket. They are glued into the 3 inboard positions as shown.
