Extraflame DELIZIA, User Manual

Page: 26 / 44

USER PARAMETERS
26
Chapter 8
Once the oven is activated and the temperature adjusted, press button 5 to confi rm and continue.
“
TIMER ” will appear fl ashing on D1 followed by “ OFF ” or a time expressed in minutes “ 000 - 255 ”; at this
point two functions can be selected: normal or timed functioning.
NORMAL FUNCTIONING (NO TIMER)
Use buttons 2 and 3 to adjust the timer to “ OFF ”. The stove will work to take the oven to the pre-established
temperature without any time limit. To confi rm and escape press button 5.
In this mode display D1 will show running “
ELECTRIC OVEN ”, while display D2 will show the current
temperature of the oven (the temperature will be shown starting from 60°C; below this the display will
show
- - - - ).
TIMED FUNCTIONING (WITH TIMER)
Use buttons 2 and 3 to adjust a desired working time. The stove will work to take the oven to the pre-
established temperature. At the end of the set working time stove display D1 will show “
END OF COOKING ”:
at this point the temperature of the oven will lower to the maintenance temperature of 70°C. Use button
5 to confi rm and escape.
In this mode, two messages will appear alternately on the 2 displays:
In this mode display D1 will show running “
ELECTRIC OVEN ” accompanied by the current temperature
of the oven on display D2 (the temperature will be shown starting from 60°C; below this the display will
show
- - - - ).
- display D1 will show “ TIMER ” accompanied by the remaining time on the timer on display D2. It will be
possible to modify the remaining time using keys 2 and 3.
WEEKLY PROGRAMMER
The weekly programmer allows to program 3 time spans within a day to use every day of the week. The
ignition and switch-off times must be within the arc of one day, from 0 to 24 and not over several days:
E.g. switch-on 07:00 / switch-off 18:00 OK
switch-on 22:00:00 / switch-off 05:00:00 ERROR
First of all the current date and time must be set using the “current date and time adjustment” sequence
to give a reference to the function itself.
To access programming press 3, hold it down and press 5 and then release both keys together. Shift
using button 5 until “
CHRONO ” appears on display D1.
The table below gives all weekly programmer parameters.
Parameter
Function
Adjustment
Keys
Value
Confi rmation
Key
Display D2 Display D1
ON/OFF Act./Deact. weekly programmer 2 or 3 CHRONO 5
UT 1 Time 1st switch-on 2 or 3 OFF or from 00:00 to 23:50 5
UT 2 Time 1st switch-off 2 or 3 OFF or from 00:00 to 23:50 5
UT 3 Consents for 1st switch on/off for various days 2 or 3 ON/OFF 1, ON/OFF 2 , … ON/OFF 7 5
UT 4 Installer parameter 2 or 3 0 5