45
Note: When the weekly programmer is on, the corresponding LED indicator on the control panel is
on
(see description of indicator lights).
TO DISACTIVATE THE WEEKLY PROGRAMMER
, enter the User Parameters by pressing
button
3
and holding it, then pressing button
5
. Display D2 shows a blinking “
0
”. Use button
2
or
3
to set
“off”
mode on display D1
.
Press button
1
to
confirm and exit.
Manual controls via the front panel or remote control take precedence over any programmed
settings.
15.2
Day/Night temperature function
The day/night temperature function makes it possible to switch the stove on/off automatically
based on two selected temperatures. This function is particularly useful when the stove heat
exceeds the setting of the room thermostat (e.g. due to mid-season temperatures or a stove that
is oversized with respect to the space).
This system enables you to select one temperature for daytime and one for night.
Before programming this function, you have to set the current day and time using the “
current day
and time setting
” instructions to provide a reference for the programming function.
To access the parameters of the day/night temperature function, press button
3
and hold it down,
then press button
5
and release both buttons at the same time. When you have entered the
function, press button
5
to move to parameter b (D2=ut b)
Parameter b (D2 = b, D1 =Ex. “06.00” )
Press button
2
or
3
to set the day period beginning/night period end.
Press button
5
to confirm and go to the next parameter.
Parameter c (D2 = c, D1 =Ex. “22.00” )
Press button
2
or
3
to set the day period end/night period beginning.
Press button
5
to confirm and go to the next parameter.
Parameter d (D2 = d, D1 =Ex. “25°C” )
Press button
2
or
3
to set the maximum temperature for the day period.
Press button
5
to confirm and go to the next parameter.
Parameter E (D2 = e, D1 =Ex. “20°C” )
Press button
2
or
3
to set the maximum temperature for the night period.
Press button
1
to confirm and exit.
When you have exited from the programming, to activate/disactivate the function, press button
4
and hold it down, press button
5
, then release both buttons at the same time.
The corresponding LED on the control panel will light up/go off (see description in the table of
indicator lights).
N.B. The stove must always be shut down while setting parameters.
Summary of Contents for BABYFIAMMA
Page 27: ...27 ...
Page 40: ...40 14 WIRING DIAGRAM General wiring diagram ...
