- 41 -
- 40 -
EN
•
FOR A LONG
BATTERY LIFETIME
y
Do not expose the compressor
to high temperatures (over
50°C) or low temperatures
(temperature around 0°C or
less), because low or high
temperature damages the
battery. For this reason, do not
leave the compressor inside
the vehicle in hot or freezing
temperatures. When the
battery is too cold, its capacity
is reduced (current flow), per-
formance and operating time
of the compressor is reduce,
and the battery is damaged.
Do not operate the compressor
when the battery is too cold.
In the event that the battery is
too cold, give the compressor
enough time to allow it to
warm up to room temperature.
y
After using the compressor,
we recommend fully charging
it so that it is not stored with
a low charge or a flat battery.
Storing the compressor with
a flat or insufficiently charged
battery damages the battery
and reduces its lifetime. When
not using the compressor for
an extended period of time,
fully charge the battery no
later than after 6 months.
y
For a longer battery lifeti-
me, we do not recommend
to run the compressor while
charging the battery.
V. Meanings of
markings on the label
Max. 50˚C
Read the user's
manual before using
the compressor.
It meets the respecti-
ve EU harmonisation
legal directives.
Connector for char-
ging using direct-
-current via USB.
Protect the compre-
ssor against rain and
high humidity and
prevent the ingression
of water into the
compressor.
Max. 50˚C
Do not expose the
compressor with
a built-in battery to
direct sunlight and
temperatures over 50°C.
Step 6
y
Short pressing the „M“ button will
start the inflation process to the pre-
set pressure. When the preset pre-
ssure is reached, the inflation process
will end automatically. In the event
that it is necessary to end (pause) the
inflation process at a lower than the
preset pressure level, short press the
„M“ button.
Step 7
y
When not using the compressor, turn
it off by setting the switch to the
„OFF“ position.
•
ATTENTION
y
During operation, do not restrict air
supply to the suction vents, which
are located on the side of the char-
ging port. Restricting air supply to
the compressor via the suction vent
reduces the inflation performance
of the compressor and may result in
the device overheating as a result of
insufficient cooling.
NOTE REGARDING
OPERATION
y
When the compressor is operated
without counter-air-pressure, i.e.
when the compressor is not conne-
cted to a tyre but it is blowing air
out into free space, after a certain
time the compressor will turn off
automatically.
y
If the battery is flat, the battery sym-
bol on the display will flash.
TURNING THE LAMP ON/OFF
y
To turn the lamp on/off, press the
button with the lamp symbol (fig. 1,
position 8).
•
NOTE
REGARDING THE USE
OF THE COMPRESSOR
y
When the compressor is in conti-
nuous operation for 10 minutes,
to ensure a long lifetime, we
recommend allowing it to cool down
before further operation.
y
Protect the compressor against
children. Ensure that children do
not play with the device. Prevent
children from using the compressor
without supervision.
y
Protect the compressor against rain
and against the ingression of water.
y
The compressor heats up during
operation.
The power tool creates an
electromagnetic field
during operation, which
may negatively affect the
operation of active or passive medical
implants (pacemakers) and threaten
the life of the user. Prior to using this
power tool, ask a doctor or the manu-
facturer of the implant, whether you
may work with this power tool.
