3 DL160-en-US_V1.6 7/22
Description and Button Functions
1.
LCD Description
Auto power off (does not apply when recording), the meter
will automatically shuts off after 5mins without any button
presses.
REC
:
Recording status. After the record mode is set up by the
software, press the START/STOP button for more than 4
seconds to begin recording. This icon will be displayed and indicates the meter is recording
data. Press the same button again for more than 4 seconds to stop recording.
Record until full is selected. When the memory is full, the datalogger will stop recording.
Continuous recording is selected. When the memory is full, the data will overwrite the oldest
data.
FULL
Memory full and recording has stopped.
Battery status, when completely filled in (black) the battery power is full. When there is only
one section filled in, the battery is exhausted and should be replaced with a new one.
2.
AC adaptor Jack
3.
ON/OFF Button
4.
MAX/MIN:
Press the button one time to display the MAX (maximum)
reading. Press again to display the MIN (minimum) reading. A third press
will exit MAX/MIN mode. The meter will automatically exit MAX/MIN mode
in 10 seconds if no button is pressed.
5.
CH Input Jacks:
Insert the current or voltage sensor to these ports to
measure and record the data.
6.
CHANNEL:
Select the channel for display on the LCD
7.
START/STOP:
After the datalogger is setup from the software, press the
START/STOP button for 4 seconds to begin recording. Press the button again for 4 seconds to stop
recording.
Recording cannot be started again until the data is downloaded to the software!
8.
USB Port
9.
AC Current Clamp Jaw:
Clamp the jaws around a single conductor
for AC current measurements to 200A
10.
Jaw Opening Trigger
11.
CH Plug
12.
AC Voltage Probes or Alligator clips
13.
Voltage module
14.
CH Plug
