CO260-en-GB_v1.0 8/17
9
Setup Mode
While the meter is OFF, long press the /SET button to enter the setup mode.
To exit the setup mode, short press the
/ESC button at any time during setup.
P10 Clearing the Manual Recording Memory
Clearing the memory will erase ALL the manually stored records.
1.
Upon entering setup mode, P10 and “CLr” display on the LCD.
2.
Short press the MXMN/AV/
button to advance to P11 and make a selection.
3.
Short press the H/
or MEM/
button to select YES or NO. ‘YES’ will erase all the
manually stored records.
4.
Short press the MXMN/AV/
button to save the selection and return to P10.
5.
Short press the
/ESC button to exit without saving.
6.
Short press the H/
button to advance to the next step.
P20 Setting the CO Alarm
1.
When in alarm setup mode, P20 and “ALAr” are displayed. Short press the H/
button
to advance to P20 if necessary.
2.
Short press the MXMN/AV/
button to advance to P21 and set the CO alarm threshold.
The current set value will blink on the display.
3.
Short press the H/
button to increase or the MEM/
button to decrease the value.
The alarm range is from 15 to 200ppm and each press of the buttons will advance 5ppm.
4.
Short press the MXMN/AV/
button to save the selection and return to P20.
5.
Short press the
/ESC
button
to exit without saving.
6.
Short press the H/
button to advance to the next step.
P30 Changing the Temperature Units
1.
When in temperature setup mode, P30 and “unit” display on the LCD. Short press the
H/
button to advance to P30 if necessary.
2.
Short press the MXMN/AV/
button to advance to P31 and change the temperature
units. The current temperature unit displays on the LCD.
3.
Short press the H/
or MEM/
button to toggle between °C and °F.
4.
Short press the MXMN/AV/
button to save the setting and return to P30.
5.
Short press the
/ESC button to exit without saving.
6.
Short press the H/
button to advance to the next step.
P40 Setting the Datalogging Sampling Rate
1.
When in datalogging setup mode, P40 and “rAtE” display on the LCD. Short press the
H/
button to advance to P40 if necessary.
2.
Short press the MXMN/AV/
button to advance to set the sampling rate for datalogging.
The hour digit will blink in the secondary display.
3.
Short press the H/
button to increase the time or short press the MEM/
button to
decrease the time.
4.
Short press the MXMN/AV/
button to save the setting and advance to the minute
setup.
5.
Short press the H/
button to increase the time or short press the MEM/
button to
decrease the time.
