Extech Instruments 42582, User Manual

Page: 8 / 14

Model 42582 Version 6.0 Sept 2007 8
To edit the fields in datalogger SETUP Screen1:
1. Use the up and down arrow keys to scroll through the parameters.
2. When a parameter is highlighted, use the
F2 EDIT
softkey to open it for editing.
3. Use the alphanumeric keypad to edit the parameter.
4. Press the
F4 ENTER
softkey to save changes. Press
F1 ABORT
to cancel
changes.
5. Press the
F1 EXIT
softkey to return to the SETUP screen.
Recording Data in the Automatic Datalogging Mode
1. After configuring the datalogger using the SETUP screen as described previously,
place the meter in position to take readings (a tripod mount is provided on the rear
of the instrument for convenience).
2. Press
F3 LOG
from the WELCOME screen and then press
F2 START
.
3. Recording will begin on the date and time programmed at the BEGIN and START
lines in the SETUP screen.
4. The Datalogger will record everyday from the START time to the SUSPEND time.
The last day that datalogging will take place is the date programmed in the END
line.
5. When the logging begins, the screen should indicate LOGGING...
6. If the screen does not indicate logging at the programmed start time, make sure the
START key is pressed. Also check the section below entitled “Automatic
Datalogging START and END date considerations” for troubleshooting.
7. To stop logging before the programmed SUSPEND time, press the
F1 STOP
softkey.
8. While logging, view data records by pressing
F4 VIEW
.
9. To print data from the list, press the
F1 STOP
, the
F4 NEXT
and then press the
F3
PRN
softkey. Press the
F2 YES
softkey when the PRINT? display appears.
10. To clear (erase) the recorded data, access the LOG mode from the WELCOME
screen. Select SET, NEXT and then press and hold the CLR (clear) softkey until
the display prompts for confirmation. Select YES to delete all records, or NO to
abort the clearing process.
Automatic Datalogging START and END Date Considerations
1. If the START date is set to a date before the current date, the datalogger will start
the moment the START softkey is pressed.
2. The datalogger will not start logging if the END date is earlier than the current date.
查询"42582"供应商