Exsys EX-41021, Installation Manual, Page: 9 / 21

Legacy SPP/EPP/ECP PCI Card
9
11. Click “ I/O Range ” , uncheck “ Use automatic settings ” , then click
“ Change Setting … ” .
12. Choose the I/O address range, please make sure it is the same as
your jumper settings, if the jumper was set at “ 3BC ” (the factory
default was “ 378 ” , in this case, you need to choose “ 0378-037A ”
instead), then the correct range selection is 03BC-03BE as shown
in the following screen shot. Please mind the conflict information