11
EX
-
1182VIS
-
2
Deutsch
© Copyright 2021 by EXSYS Vertriebs GmbH. All Rights Reserved
4. Hardware Installation
5. Driver Installation
All Operating Systems
After the hardware installation the operating system will recognize the device automatically and
install the drivers.
CHECK INSTALLED DRIVER
Open the >
Device manager
<. Now you should see at
„
USB
-
Controller
“
the following new entry's:
If you see this or a similar information the device is installed correctly.
6. Cleaning
For cleaning please use only a dry fluff less cloth and remove the dirt with gently pressure. In the
area of the connectors please make sure that no fibres from the cloth remain in the connectors.
Attention! Never use a moist or wet cloth for cleaning!
Because there are large differences between PC
’
s, we can give you only a general installation
guide.
Please
refer
your
computer
’
s
reference
manual
whenever
in
doubt.
1.
Install the EX
-
1182VIS
-
2 on a DIN
-
Rail using the supplied DIN
-
Rail kit or on a wall using the
wall mounting kit.
2.
Now connect the USB cable to the USB 3.2 Gen 1 B
-
Port at the Hub.
3.
Now connect the power connector of the included power supply to the 5V connector of the hub
and plug the power plug of the power supply into a power outlet.
4.
Last connect the other end of the USB cable (A
-
Plug) to the USB A
-
Port at your PC.
