9
CLEAN THE FREEZER REGULARLY.
Note: before cleaning the cooling device and its rear compartment part, the
device must be disconnected from the mains by unplugging.
•
Protect the appliance inner surfaces and plastic parts from fats, acids and sauces. In case of
accidental spills
–
immediately clean with warm soapy water or dishwashing detergent. Wipe
dry.
•
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
At least once a year clean dust away from the back part of the appliance body and the
compressor. A soft brush, electrostatic cloth or vacuum cleaner may be used for cleaning.
•
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for cleaning
the appliance inner and outer surfaces. DO NOT use for cleaning cloths or sponges that have
coarse surfaces intended for scrubbingIf the appliance is to be left switched off for an
extended period, leave its doors open.
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors YOU CAN NOT lay the refrigerator
horizontally!
Before you get started, please note the following:
∙
Always ensure that the correct number of washers are used on the hinge bolts.
∙
To ensure that the door can close tightly against the frame, take the utmost care that it is
properly aligned during reassembly.
Do the actions below in the order they are listed (see fig. 6, page 2):
W A R N I N G !
Turn off the freezer and pull the plug out of the electricity supply outlet.
1. Remove covers
c
from the inside of the housing and door and the upper bracket
6
together
with the nut and washers and the gasket under the bracket.
2. Remove the freezer door
1
. Remove the stop plate from the bottom
2
. Screw the stop plate
(included in the package) on the opposite side of the door to open the door to the left.
3. Remove the bottom cover
3
together with the small cover
4
.
4. Unscrew the shaft
5
together with the washers on the shaft and the catch
8
from the lower
bracket
6
and screw them to the bracket
7
on the other side of the cabinet symmetrically to the
former position.
5. Push the freezer door onto the bracket
7
on the newly installed shaft
5
.
6. Remove the screw caps a and the blinds
b
. Unscrew the
9
fixing screws of the handle and
screw the handle on the opposite side of the door. Press the blinds into the remaining holes in
the door and place the covers on the screws.
7. Rotate the bracket
6
together with the washers on the shaft and the plastic gasket at an
angle of 180 °. Unscrew the shaft together with the washers and screw in on the opposite side
of the bracket. After inserting the axis
6
of the bracket into the door of the refrigerator
compartment, screw it on the opposite side of the refrigerator in the lower holes. Cover
c
with
the bracket and the remaining empty cavity.
8. Insert the cover
4
into the guides on the opposite side of the bottom cover
3
. Replace the
bottom cover
3
in its original position.
Operation problems and their solutions.
What if …
•
The appliance is plugged in to the mains but it does not work and the electricity supply
voltage indicator is not illuminated.
Check that your house electricity supply installations are in
order. Check that the plug is correctly inserted into the electricity supply socket.
