Express Water Commercial Reverse Osmosis System, Installation Manual

Page: 11 / 28

5
Tubing Quick Connect Guide
To Cut Tubing
M ake your cuts against a flat cutting surface with a razor blade, or use a handheld tube cutter. Any cuts to
your Tubing must be perfectly straight.
NOTE!
Improperly cut Tubing may leak water or fail to lock into Fittings.
Wait until all elements of your RO System are in their final locations before cutting your Tubing.
Make sure you measure the length you will need before cutting. Please avoid unnecessary additional tubing
as it will affect the efficiency of your water production and delivery.
Attach Tubing
Push Tubing in straight and level with
the Collet. The Tubing will go 13/16ths of
an inch into the Collet before the lock is
activated. Pull out on the Tube to make
sure the lock has activated and the Tubing
is secure.
13/16”
13/16”
The tubing in your RO System uses a Quick Connect locking mechanism to lock the tubing in place. Be
careful not to damage your tubing as you unpack it.
NOTE!
Make sure to remove any plugs before attempting to insert tubing.
Plug
Collet
Fitting
Release Tubing/Plugs
Push and hold the Collet in to release the lock
while pulling out on the Tube/Plug.
NOTE! Collet must be held down while
pulling up on the tube to release the tube.
Hold
Down
NOTE! Once connected,
make sure to check
tubing is secure.