www.exposurelights.com
6
1
2
3
4
Quick Release Bracket – MaXx-D, Toro,
Strada (Diablo with clip), Race
The Exposure QR bracket is a triumph in design that brings to life the full
benefit of Exposure’s principle feature, Cable Free Design (CFD). The light
unit is easily and quickly attached and removed. The bracket stays with the
bike and the light will be in the perfect position every time it is attached.
• Mounting to a 31.8mm bar – Remove the spacer from the bracket.
Peel backing of the rubber strips and attach to the inside of the metal
bracket. Fit the bracket to the bar. Tighten the clamp with a 4mm hex key.
(Maximum 2.5Nm) DO NOT OVER TIGHTEN!
• Mounting to a 25.4 or 26mm bar - Clip the plastic spacer over your bar,
attach the bracket over the spacer and tighten the clamp with a 4mm hex
key. (Maximum 2.5 Nm) DO NOT OVER TIGHTEN!
1 Attach the cleat to the light unit using
the provided bolt (Already fitted to
new lights).
2 Locate the cleat into the V section of
the bracket and slide forward until the
steel pin “clicks” into place
3 To adjust the angle of the light, loosen
the cleat bolt. A hole in the bracket
enables access to the bolt when the
light is in the bracket. Use a 4mm
hex key to adjust and tighten the bolt
securely (Maximum 2.5Nm)
4 To release the light from the bracket
push away and down on the red
button and gently pull back the light
with your hand. This is a simple
one-hand operation.
• Warning - Make sure that brake
and gear cables cannot catch on or
interfere with the light or the bracket or
release button.
• Warning: Racers beware - check
number boards do not interfere with
bracket button. If the steel pin can
not pop-up fully the light will not be
fully engaged to the bracket and may
come off.
QR bracket also available as accessory:
EXPQRBK-10 Bracket Only (no cleat or bolt)
EXPQRBKSET Bracket with clip for Joystick/Diablo/Spark