2.3
SETTING UP WITH A DMX512
CONTROLLER
2.3-1 DMX512 ADDRESSING WITHOUT ID ADDRESSING
(STUDIO 2 MODE)
The figure above shows a simple DMX512
layout with the starting address of the first
unit set at 1, with the second set at 7 and
so on... (Note that when used in this way,
the CH6 ID function must be inactive (CH6=0))
DMX512
CONTROLLER
Connect the DMX512 controller to the units in series.
Each unit has 6 DMX channels so the DMX Addresses should increase by increments of
6 (e.g. 1,7,13,19...)
The ID address has not been set so therefore when using the controller CH8 must
be inactive ( CH6=0 ).
It is also possible to deactivate ID address selecting
ID OFF
from the
Settings
menu.
on the fixture
Each DMX Address may be used as many times as required.
Any DMX address in the range from 001 to 512 may be used.
2.3-2 DMX512 ADDRESSING WITH ID ADDRESS (STUDIO 2 MODE)
Connect the DMX512 controller to the units in series
Each unit has 6 DMX channels so the DMX Addresses should increase by increments of
6 (e.g. 1,7,13,19...)
Each DMX Address may be used as many times as required.
Any DMX address in the range from 001 to 512 may be used.
Each DMX address may carry up to 66 separate ID addresses.
ID
should be set in the menu on each unit in ascending values
(i.e. 1,2,3...)
ID On
should be set in the
Settings
menu on each unit.
ID addresses are accessible from CH6 on the DMX512 controller.
Example:
5
2 INSTALLATION
............
DMX Addr.1
DMX Addr.7
DMX Addr.13
2008.9.19
Summary of Contents for TOURLED 36 CW
Page 1: ...USER MANUAL...
