Expolite led22550, User Manual

Page: 31 / 44

Choose Run Mode
The operating mode is set in menu RUN . For operation on a DMX-controller DMX needs to be
set. SLAV sets the fixture into slave mode.
MENU
Edit User Programs
In the menu EDIT the user programs PR.01 to PR.10 can be edited. Every program can have up to
30 steps (scenes). Every step persists of the parameter colours RGBW ( R./G./B./W. ), STROBE ( S. )
„0-20Hz“, TIME ( T. ) and FADE ( F. ). User programs can be transfered to other fixtures
(see master/slave).
Step-by-step programming of the custom stand-alone programs with up to 30 different steps.
NOTE: For less than 30 steps the TIME ( T. ) and FADE ( F. ) of the last step needs to be set to 0.
Example for time settings of a stand-alone programm with 3 steps:
Step 1
T . = 4 F . = 3
Step 2 T . = 5 F . = 2
Step 3 T . = 0 F . = 0
MENU
E-31
PERSON RUN HSIC DMX
HSIC SLAV
HSIC EDIT PR.01
PR.02
o
o
o
PR.10
SC.01
SC.02
SC.30
o
o
o
R.(0 - 255)
G.(0 - 255)
B.(0 - 255)
W.(0 - 255)
S.(0 - 20)
W.(0 - 255)
T.(0 - 255)
F.(0 - 255)
In the menu AUTO PROGRAM the automatic programs stored in the device are activated. The
programs AT01 to AT10 are permanently stored in the device. The programs Pr01 to PR10 are
editable. This is described under Edit User Programs . Automatic programs are transmitted as
master to connected slave devices. For master-slave operation, signals are sent via the DMX line.
This may disturb other devices on the same line.