2. SETTING PERSONAL CODE AND OPENING
With the door in the open position. Press the red reset button (1) on the back of the
door. Enter your personal code (It is recommended to use four numbers) and press
button “E” to confirm. You will hear a bleep tone.
3. WARNING
Before closing the door check that the new codes are in operation. Enter your new
personal code and press button “E” to confirm. The green indicator will light fol-
lowed by a beep tone. The safe is now ready for use.
4. LOW POWER WARNING
Replace batteries immediately when the red warning light is illuminated 4. Once the
new batteries have been inserted reset the personal code following step 2.
5. MANUAL OVERRIDE
Follow instructions in item 1.
6. REPLACEMENT BATTERIES
When the batteries are low the red indicator light will be illuminated when the key-
pad buttons are pressed. The lock uses 4 x AA batteries located in the battery holder
(2).
Please replace these as soon as possible
. On replacing the batteries
you must reset your personal code, following the instructions in step
2. Used batteries should not be disposed of with normal domestic
waste. These should be disposed of at approved collection points. You
may also return used batteries to your Retailer at their expense (where
applicable).
7. HOW TO REPLACE BATTERIES
Remove the grey plastic cover from between the circular handle and the keypad.
Now insert the override key and turn clockwise. Turn the circular handle and open
the safe door. On the inside of the door you will see the cover to the battery pack,
remove this; take out the dead batteries and replace with new ones.
Replace the cover to the battery pack; close the door and turn the override key anti-
clockwise. Remove the key and replace the grey plastic cover.
6
