ALARM
SETTING / ADJUSTING ALARM TIME
1.Press [ ] triple to enter alarm 1 setting mode.
The [ ] will be on. (Press four times to enter
alarm 2 setting mode. The [ ] will be on.)
2. The setting parameter will flash.
3. Press and hold [ ] button to confirm setting
and enter to next parameter.
4. Press [ ] or [ ] to set the required data.
5. Sequence of setting: Hour
->
Minute
->
Alarm
OFF/ON
6. If there is no action in 3 seconds, the setting
will be saved and will exit the setting mode.
OPERATION
1. At the set time, alarm signal rings.
2. The alarm lasts 1 minute.
3. To stop the alarm, press [ ].
4. During the alarm, press any other button to
delay the alarm by 5 minutes.
5. The alarm will start again at the next alarm
time, unless you switch off the alarm function.
NOTE:
a. The alarm will automatically turn off after 4
times of snooze.
b. The screen will be turned on when the alarm
rings during Power OFF.
6
EC DECLARATION OF
CONFORMITY
Hereby, Explore Scientific GmbH declares
that theequipment type with part number:
BCC1001 is in compliance with
Directive: 2014/53/EU. The full text of the EU
declaration of conformity is available at the
following internet address: www.bresser.de/
download/BCC1001/CE/BCC1001_CE.pdf
SPECIFICATIONS
Dimensions (Main unit):
204x79x109mm (LxWxH)
Weight (Main unit):
820 g (Exclude batteries)
Power:
Micro USB charging cable, DC 5V, 1.5A
Bluetooth standard:
5.0
Output Power:
5W * 2
Batteries:
2200mAh*2
NOTES ON CLEANING
• Remove the batteries before cleaning.
• Only use a dry cloth to clean the exterior of the
device. To avoid damaging the electronics, do
not use any cleaning fluid.
• Protect the device from dust and moisture.
RCM DECLARATION OF
CONFORMITY
The product complies with electrical
safety, EMC and radio spectrum regulatory
requirements for products supplied to
the Australia or New Zealand market.
Wireless Charging Power:
5W
Output Voltage:
5V
Output Current:
1A
