9
4.2.3
Transmitting data to the receiver
To program the receiver, it must be connected to the PC by use of the Steppercable and its Adapter,
or the Bootloadercable in case of the X2-series. Before programming, the device must be switched
off.
As soon as the device is connected to the PC, the transmission of the steppersoftware can be started.
Click the Transmit-Button (see picture below).
On the right side of the window opening now, you can select the COM-Port.
Activate the receiver now. The red LED should start to flash rapidly now. Should it not, the receiver is
not getting a correct signal from the PC, and the transmission should be restarted.
If the LED flashes correctly, you can continue the transmission by clicking "OK". Wait for the
transmission to finish, which it has as soon as you see the below window.
5
Technical Data
Standby:
ca. 8 hours
Range:
ca. 800 Meters
Ignition energy:
9 V (max. 1 A-Igniter 10 Ω; max. 1 U-Igniter 8 Ω)
Measurements:
79x60x23mm
Weight:
120g
