11
Operating Instructions
This grill is designed to operate with a 1 lb .
7 .75 in . or 10 .6 in . high disposable / 16 .4 oz . or 14 .1 oz . propane gas tank (DOT 39 Cylinder) (Figure 1) .
DO NOT ATTEMPT TO REFILL ANY 1 lb. (16.4 oz. or 14.1 oz.) PROPANE GAS TANKS!
Connecting LP Gas Tank
Only cylinders marked “propane” may be used.
W
CAUTION: The gas pressure regulator provided with this appliance must be
used. Replace only with regulator model # R801 / KR-101.
Note: 1 lb cylinders may form frost when near empty .
1 . Make sure the regulator/control knob is in the “ OFF” position (Figure 2) .
2 . Lubricate the threads of the regulator/control knob with petroleum jelly . Line up threads on LP gas
tank with regulator/control knob .
3 . Insert and rotate LP gas tank clockwise until they fit snugly together . HAND TIGHTEN ONLY . Be
careful not to crossthread when screwing in tank (Figure 3) .
4 . Perform leak test per “Checking for Leaks” section .
Disconnecting LP Gas Tank
1 . Turn the regulator/control knob to the “ OFF” position (Figure 2) .
2 . Rotate LP gas tank counterclockwise until it is detached (Figure 4) .
3 . Store the LP gas tank in a proper location, per instructions on the LP gas tank .
Checking for Leaks
Burner Connections
1 . Make sure the regulator/control knob is securely fastened to the burner .
Note: The brass nut should be 1/4 to 1/2 turn past tight . The regulator will rotate 360º even when the
brass nut is tightened .
If your unit was assembled for you, visually check the connection between the burner and
regulator/control knob (Figure 5) .
W
WARNING: Failure to inspect this connection or follow these instructions
could cause a fire or an explosion which can cause death, serious bodily
injury or damage to property.
2 . If the burner and regulator/control knob do not fit properly or if you have any questions, please
contact 1 .800 .694 .0013 for assistance .
Tank/Gas Line Connection
1 . Make 2-3 oz . of leak detection solution by mixing one part liquid dishwashing soap with three
parts water .
2 . Make sure regulator/control knob is in the “ OFF” position (Figure 2) .
3 . Spoon the leak detection check solution on all “X” locations (Figure 5) .
a . If any bubbles appear, remove the LP gas tank and reconnect, making sure the connection is
secure .
b . If you continue to see bubbles after several attempts, remove the LP gas tank per
“Disconnecting LP Gas Tank” section, and contact 1 .800 .694 .0013 for assistance .
c . If no bubbles appear after one minute, turn regulator/control knob to the “ OFF” position,
wipe away solution and proceed .
First Use
1 . Make sure all labels, packaging and protective films have been removed from the grill .
2 . Remove manufacturing oils before cooking on this grill for the first time by operating the grill for at
least 15 minutes on (HIGH) with the lid closed . This will “heat clean” the internal parts and dissipate
odors .
Figure 1
1 lb
453 g
7.75 in.
/ 19,7 cm
3.875 in. / 9,8 cm
2.9 in. / 7,4 cm
1 lb
465 g
10.6 in.
/ 27 cm
Figure 2
OFF
APAGADO
Figure 3
Figure 4
Figure 5
X
X
