13
Operating Instructions
Checking for Leaks
Burner Connections
1 . Make sure the regulator hose and valve connections are securely fastened to the burner
and the tank .
2 . Visually check the connection between the burner/venturi tube and orifice .
3 . Make sure the burner/venturi tube fits over the orifice .
W
WARNING: Failure to inspect this connection or follow these
instructions could cause a fire or an explosion which can cause
death, serious bodily injury or damage to property.
4 . Please refer to diagram for proper installation (Figure 1) .
5 . If the burner/venturi tube does not rest flush to the orifice, as shown .
Tank/Gas Line Connection
1 . Make 2-3 oz . of leak detection solution by mixing one part liquid dishwashing soap with
three parts water .
2 . Make sure control knobs are in the “ OFF” position (Figure 2) .
3 . Connect LP gas tank per “Installing LP Gas Tank” section .
4 . Turn LP gas tank valve to “OPEN .”
5 . Spoon several drops of solution, or use a squirt bottle, at all “X” locations (Figures 1 and
3) .
a . If any bubbles appear, turn LP gas tank valve to “CLOSED,” reconnect and re-test .
b . If you continue to see bubbles after several attempts, turn LP gas tank valve to
“CLOSED” and disconnect LP gas tank, per “Disconnecting LP Gas Tank” section .
c . If no bubbles appear after one minute, turn LP gas tank valve to “CLOSED,” wipe
away solution and proceed .
Figure 1
Figure 2
Figure 3
X
X
X
X
X
Figure 4
Match
Lighting Hook
Figure 5
Burner
Flame
Slight
Yellow
Slight
Blue
Dark
Blue
Operating Main Burners
First Use
1 . Make sure all labels, packaging and protective films have been removed from the grill .
2 . Remove manufacturing oils before cooking on this grill for the first time by operating
the grill for at least 15 minutes on (HIGH) with the lid closed . This will “heat clean” the
internal parts and dissipate odors .
Lighting
W
CAUTION: Keep outdoor gas cooking appliance area clear and free from
combustible materials, gasoline and other flammable vapors and liquids.
W
CAUTION: Do NOT obstruct the flow of combustion and ventilation air.
W
CAUTION: Check and clean burner/venturi tubes for insects and insect nests. A
clogged tube can lead to a fire.
W
CAUTION: Attempting to light the burner with the lid closed may cause an
explosion.
1 . Open lid .
2 . Check for obstructions of airflow to the burners . Spiders, insects and webs can clog the
burner/venturi tube . A clogged burner tube can lead to a fire .
3 . All control knobs must be in the “ OFF” position (Figure 2) .
4 . Connect LP gas tank per “Installing LP Gas Tank” section .
5 . Turn LP gas tank valve to “OPEN .”
6 . Push and turn control knob to (HIGH) . the burner should light . Repeat up to three times .
7 . If ignition does not occur in 5 seconds, turn burner control knob “ OFF,” wait 5 minutes,
and repeat lighting procedure .
8 . If igniter does not light burner, use a lit match secured with the lighting rod (included with grill) to light burners . Access the burners
through the cooking grid and heat plates . Position lit match near side of burner (Figure 4) .
Important:
Always use the lighting rod (included) when lighting burners with a match .
9 . After lighting, observe the burner flame . Make sure all burner ports are lit and flame height matches illustration (Figure 5) .
Note
: Each burner lights independently - repeat steps 5-9 for the other burners .
