Expero Omega SAT, User Manual, Page: 5 / 16

~ 3 ~
TURNING ON THE OVERRIDE MODE WITH THE HELP OF THE OVERRIDE
BUTTON
The most convenient way to turn ON the override mode is to enter the PIN
code with the override button. If the override button is installed, check your
notes with the alarm system's PIN on, press the override button as many times
as the value of the first digit of the PIN (the time between the presses should
not exceed 1 second) and wait for a 1 second lasting LED flash, which will
mean that the first digit is entered successfully. In the same way enter the
second, third and fourth digits of the PIN.
To the next presses of the override button the system will respond as if the
PIN code is being entered.
TURNING ON THE OVERRIDE MODE WITH THE IGNITION KEY
If the override button is not installed, open the vehicle's door and turn the
ignition ON. Shortly after the system LED starts flashing double flashes, count
until the number of double flashes (1 double flash = 1 unit) corresponds with
the first digit of the PIN code. Turn the ignition OFF for a short time and turn it
ON again. Count the double flashes until the number corresponds with the
second digit of the PIN code. Turn the ignition key OFF and ON again. Enter the
remaining two digits of the PIN code in the same way. Upon correct entry of all
four digits of the PIN code the LED emits frequent flashes.
If you make a mistake while entering the PIN code, turn OFF the ignition,
close the doors, and follow all over again.
TURNING OFF (EXIT) THE OVERRIDE MODE
Enter the PIN code and enter the code '11' within 8 minutes of the previous
step.