Filling
1.
Remove the 2 white caps from the screw covers on the bottom front of the bubble wall. A
small flat bladed screwdriver can be used to prise these off.
2.
Remove the 2 screws and the white plastic cover to reveal the drain/fill valve.
3.
Take the foot pump, and connect the pipe with the white male connector to the valve on the
bottom of the Bubble Wall.
4.
Fill the bucket with clean water. We recommend the use of BCB fluid (sold separately), if you
are using BCB fluid, please add it now as per the instructions that are supplied with the BCB
fluid.
5.
Put the hose without a connector on into the bucket of water.
6.
Slowly start stepping on and off the foot pump to start filling the Bubble Tube.
7.
When the water starts entering the tank slow the stepping action down so the pressure of
the water entering the tank isn’t too great.
8.
DO NOT FILL THE TANK COMPLETELY! Once the Bubble Wall is switched on, the air
displacement caused by the internal pump to create the bubbles will cause the water level
to rise. Over filling will cause water to leak from the top of the tank causing internal damage.
9.
Fill the tank so that the water is level with the fill level mark (approx. 30cm from the top.)
10.
If you find you have over-filled the Bubble Wall, use the drain hose as detailed in the section
above, titled ‘Emptying’, to remove the excess water.
Troubleshooting
Q. The unit doesn’t work.
A1. Is it switched on? If so, see A2
A2. Has the unit scrolled through its colours? If so, see A3
A3. Has the unit been paired to an IRiS Talker? If so, see A4
A4. Is the battery in the IRiS Talker fully charged? If so, see A5
A5. Have you tried a different IRiS Talker? If so, please contact us.
