- 3 -
Getting Started
1. Remove all packaging around the bubble wall. Please note, the tank may
contain a small amount of water, this is completely normal.
2. Place the Calming LED Bubble Wall on a flat solid floor.
3. Secure the Bubble Wall to a solid wall using the correct fixings for the wall
type. If fixing plates are provided (see separate wall fixing instructions).
If not, then remove the Bubble Wall back by unscrewing the screws and
mount the Bubble Wall back on the wall and then position the bubble wall
over the wall mounted back and re-screw the Bubble Wall onto its back.
4. Remove the white plastic cover at the bottom of the tank to reveal a valve.
5. This valve allows the pump (provided) to be used to fill the bubble wall
tank.
6. This is done by inserting the Pump pipe with the white plastic end into the
bubble wall valve and dipping the other Pump pipe into a clean bucket of
water.
7. By gently stepping on the foot pump the water is transferred into the
bubble wall tank. Once the tank is three quarters full,
stop
filling.
DO NO
FILL THE TANK WITH WATER
as this will cause it to leak once switched
on. Remove the pipe from the bubble wall valve. Clean any drips away
from the valve and make sure it has closed.
8. If you feel you have filled the tank too far then insert the emptying pipe
with a white plastic end into the bubble wall valve (with the other end over
the bucket) to allow some water out.
9. Connect the round XLR connector (silver connector with grey cable) from
the Low Voltage transformer to the socket on the bottom side of the
bubble wall.
10. Connect the standard mains plug to a mains outlet.
11. The Bubble Wall will now illuminate and scroll through the standard
colours and is now ready for use.
