7
The edger attachment is fully assembled at the factory and
requires no further assembly.
JOINING THE POWER HEAD TO THE EDGER
ATTACHMENT
See Figure 2.
WARNING:
Never attach or adjust any attachment while power head is
running. Failure to stop the engine can cause serious
personal injury.
The edger attachment connects to the power head by means
of a coupler device.
1. Loosen the knob on the coupler of the power head shaft
and remove the end cap from the edger shaft.
2. Push in the button located on the edger attachment
shaft. Align the button with the guide recess on the
power head coupler and slide the two shafts together.
Rotate the edger attachment shaft until the button locks
into the positioning hole.
EDGER ATTACHMENT
NOTE: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked into
place.
3. Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious injury.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
1. Loosen the knob.
2. Push in the button and twist the shafts to remove and
separate ends.
POWER HEAD SHAFT
GUIDE RECESS
COUPLER
KNOB
POSITIONING
HOLE
Fig. 2
ASSEMBLY
