EXP X-800C, Operating Instructions Manual

Page: 23 / 28

23
CHAPTER 6: X-800C SPECIFICATIONS
X-800C Specifications
ACOUSTICAL
Operating Frequency
Range 20 Hz – 200 Hz
Note: Recommended maximum operating frequency range. Response depends on loading condi-
tions and room acoustics.
Frequency Response 23 Hz – 160 Hz ±4 dB
Note: Measured free field with 1/3 octave frequency resolution at 4 meters.
Phase Response 32 Hz to 175 Hz ±30°
Maximum Peak SPL 136 dB
Note: Measured with music, referred to 1 meter.
Dynamic Range >110 dB
Coverage 360° for a single unit; varies with number of units and configuration
TRANSDUCERS
Low Frequency Two 18” cone drivers
Nominal impedance: 8

Voice coil size: 3”
Power-handling capability: 600 W (AES) each
Note: Power handling measured using AES standards: transducer driven continuously for two
hours with a band limited noise signal having a 6 dB peak-average ratio.
AUDIO INPUT
Type Differential, electronically balanced
Maximum Common
Mode Range ±15 V DC, clamped to earth for voltage transient protection
Connectors Female XLR input with male XLR loop output
Input Impedance 10 k

differential between pins 2 and 3
Wiring Pin 1: Chassis/earth through 220 k

, 1000 pF, 15 V clamp network to provide virtual ground lift at
audio frequencies
Pin 2:
Pin 3: Signal –
Case: Earth ground and chassis
DC Blocking None on input; DC blocked through signal processing
CMRR >50 dB, typically 80 dB (50 Hz – 500 Hz)
RF Filter Common mode: 425 kHz

Differential mode: 142 kHz
TIM Filter <80 kHz, integral to signal processing
Nominal Input Sensi-
tivity 0 dBV (1.0 V rms, 1.4 V peak) continuous is typically the onset of limiting for noise and music
Input Level Audio source must be capable of pro20 dBV (10 V rms, 14 V peak) into 600

to produce
the maximum peak SPL over the operating bandwidth of the loudspeaker
AMPLIFIER
Type Two-channel complementary MOSFET output stages (class AB/H)
Output Power 1240 W total (2 x 620 W)
Note: Wattage rating based on the maximum unclipped burst sine-wave rms voltage the amplifier
will produce into the nominal load impedance; both channels 70 V rms (100 V peak) into 8 ohms.