2
C
ONNECTING TO A
12
V
OLT
A
CCESSORY
O
UTLET
The HeatBuddy Jr. is simple to set-up and operate. Every HeatBuddy Jr. is supplied with a 12 Volt
Accessory Outlet Power Cable and adapter. (The P25S13 Adapter is required only when using the 12 Volt
Accessory Outlet Power Cable.) Merely plug the HeatBuddy Jr. in and sit on it, lean up against it, wrap
around you, etc. to immediately enjoy and benefit from the unique heat produced only by FabRoc™ Heat
Technology by EXO2.
U
SING THE
O
PTIONAL
12
V
OLT OR
15
V
OLT
M
ULTI
-L
EVEL
R
ECHARGEABLE
B
ATTERY
1.
Plug in the HeatBuddy Jr.’s 1.3mm lead into the 12 Volt or 15 Volt Multi-Level Rechargeable Battery
port and press and hold the
ON
button until the battery LED screen illuminates.
2.
Use the
UP
button to increase the power level (therefore increasing the heat level) to the desired
temperature. (The temperature at each level will depend on the ambient environment, how the
HeatBuddy Jr. is used, the selected power level, etc.) Level 5 is the highest setting. Use the
DOWN
button to decrease the power level (therefore decreasing the heat level) to the desired
temperature. Level 1 is the lowest setting. Once the desired heat level is selected, the LED will
blink for 5 seconds. After 5 seconds, the amount of battery life remaining
(1-9, 9 being fully charged) will appear to alert to you the pending battery
life.
3.
Use the
OFF
button or merely unplug the 1.3mm lead to turn the
HeatBuddy Jr. off.
4.
To charge the battery, connect the EXO2 16.8 volt supplied charger to the
battery port and plug the charger’s plug into a 110v household electrical
outlet. The number which shows in the display window indicates your
charge level (1-9, 9 being fully charged). The LED on the charger will turn
green and the battery LED will read “9” when the battery is fully charged.
5.
It normally takes about 3 hours for the battery to fully charge if it was fully discharged. (The EXO2
Lithium-Ion batteries have no “memory” and it is not necessary to fully discharge the battery
before recharging it.)
6.
The HeatBuddy Jr. will operate from 4-8 hours depending on the heat level selected.
The charger unit supplied has been chosen specifically for the EXO2 battery packs.
No other charger
should be used. The use of any other charger unit is dangerous, may cause injury and will void the
warranty.
G
ETTING THE
B
EST
R
ESULTS
The HeatBuddy Jr. is intended to be placed in close proximity to the target surface. Always use the
supplied cover when using the HeatBuddy Jr. Replacement covers can be ordered at
S
AFETY
F
EATURES
The HeatBuddy Jr., with FabRoc™ Heat Technology, has been designed for safe and reliable use.
DO NOT
use on/with/for a child or anyone who cannot tell you if the HeatBuddy Jr. is too hot.
DO NOT
use an alternative power supply source even if the 1.3mm plug fits.
Power supplies have been tested to comply with CE safety regulations and have been marked with the
CE seal of approval. Safety devices are included to ensure these units are rendered safe, even under
faulty conditions.
