12
Installation – Other Terrarium Models
Refer to your terrarium’s instruction manual for instructions on how to install
equipment, wiring and tubing inside the terrarium.
1. Mount the nozzles in position on the glass portion of the terrarium’s
side panels with the suction cups. Make sure that the glass area is
clean and free of any dirt or deposits before mounting the nozzles.
For the best results, mount the nozzles as close as possible to the
front opening windows and the top screen.
2. Direct the nozzle positions inside the terrarium so that the spray
stream will avoid spraying on the terrarium’s front and side panels
when in operation.
3. Use the additional suction cups to neatly guide the tubing along the
side panels to the inlet location of your terrarium.
4. Connect the tubing from the nozzles to the Y-connector by pressing
the tubing firmly into one of the side-by-side holes as far as
possible. Connect both nozzles.
5. Connect the tubing to the remaining hole of the Y-connector by
pressing it firmly inside as far as possible.
6. Place the Monsoon MULTI unit on a hard, stable, level surface.
7. Connect the tubing coming from the Y-connector to the top of the
unit by pressing the tubing firmly into the opening as far
as possible.
8. Make sure that the filter is properly connected to the spigot on the
underside of the control unit and placed inside the reservoir.
9. Ensure that the top of the Monsoon MULTI unit fits tightly on top
of the reservoir.
10. Open the small lid on top of the unit, and fill the reservoir with de-
mineralized/distilled water up to a maximum of 2,5 cm (1”) from
the top rim of the transparent reservoir. (Using regular tap water
will cause clogging of the nozzles by mineral deposits!)
11. Close the lid and connect the power supply jack to the back of
the unit.
12. Make sure the unit is in its final operating location, standing level
on a hard surface.
13. Plug the power adaptor into the wall socket, your Exo Terra
®
Monsoon MULTI High-pressure Misting system is now ready to
use. In order to remove the tubing from either the Y-connector
or the unit, press and hold the blue ring down, while pulling out
the tubing. Please note that nozzles can be mounted in multiple
terrariums.
Operating instructions
Use one of the three operating modes mentioned below to create the
appropriate rain cycle for your animals. You can switch between the
operating modes by pressing one of the three buttons in the center of
the control panel (fig. G):
1. O
: The Exo Terra
®
Monsoon is switched off – No blue LED light is
visible in this mode.
2. ON
: The Exo Terra
®
Monsoon is switched on – the blue LED “ON”
light is illuminated and the unit will operate CONTINUOUSLY. The
blue LED lights that indicate the cycle settings (duration and cycle)
are illuminated and will show which cycle parameters will be
used when the mode is switched to “CYCLE” mode (see below).
PLEASE NOTE THAT IN THIS MODE THE MONSOON WILL NOT
SPRAY ACCORDING TO THESE CYCLE SETTINGS, IT WILL SPRAY
