- 17 -
4.1.11
Drive Wheel Release Valves: Located on the left rear corner of the hydrostatic
pumps. Drive wheel release valves are used to release the hydro-static drive
system to allow the machine to be moved by hand without the engine running.
With a 5/8 wrench, turn both valves one turn counter-clockwise to release the
drive system.
Turn clockwise to reset the drive system.
Do Not over tighten.
4.1.12
Tracking Adjustment Knob: Located on the right-hand side of the rear of the fuel
tank support. The knob can be adjusted so that machine will “track” straight
ahead with the drive levers released.
4.1.13
Park Brake Lever: Located on the left side of the unit above the hydraulic tank.
The brake lever engages the park brake on the drive wheels.
Pull
the lever
up
and
rearward
to engage the brake.
Push
the lever
forward
and
down
to disengage the brake.
When parking on a steep slope, the wheels must be chocked or blocked in
addition to the brake being engaged. The unit must be tied down and brake
engaged when transporting,
Park brake must be disengaged to move speed control out of neutral or engine
will kill.
4.2
PRE-START
4.2.1
Fill fuel tank. For best results use only clean fresh regular grade
unleaded
gasoline with an octane rating of 87 or higher. Regular grade leaded gasoline
may also be used; however, combustion chamber and cylinder head will require
more frequent service. See Engine Owner's Manual. Do not add oil to gasoline.
Do Not
overfill fuel tank. Never fill the fuel tank so that the fuel level rises above
a level that is 1/2” below the bottom of the filler neck to allow for fuel expansion
and prevent fuel spillage.
4.2.2
Refer to Maintenance and Adjustment Section 5 and perform all of the necessary
inspection and maintenance steps.
4.2.3
Make sure you understand the controls, their locations, their functions, and their
safety requirements.
4
.
3
OPERATING INSTRUCTIONS
4.3.1
Starting Engine: Open fuel valve.
Operator must have
Operator Presence Control (OPC) levers
depressed
, the
PTO
disengaged
and
speed control lever in
neutral
.
On a cold engine, place the throttle midway between the “Slow” and “Fast”
positions and place the choke in the “On” position. On a warm engine, place the
throttle lever midway between “Slow” and “Fast” positions and leave the choke in
the “Off” position.
Turn ignition switch to “Start” position. Release the switch as soon as the engine
starts.
On a cold engine, gradually return choke to the “Off” position after engine starts
and warms up.
IMPORTANT: Do not crank the engine continuously for more than ten (10)
seconds at a time. If the engine does not start, allow a 60 second starter
cool-down period between starting attempts. Failure to follow these
guidelines can burn out the starter motor.
NOTE:
It is helpful to have the left and right neutral lock latches locked in
neutral when starting the engine, See Controls Section 4.1.3.
