Setup
Installing the Mount Plate:
Align the mount plate to the rear surface of the
engine deck.
Install the mount plate to the engine deck using four
3/8-16 x 1 1/4 inch hex screws, two backup plates,
and four 3/8-16 inch nyloc nuts as shown in Figure 3.
Figure 3
1.
3/8-16 x 1 1/4 inch hex
capscrews
3.
Backup plates
2.
Mount plate
4.
3/8-16 inch nyloc nuts
Mounting the Drawbar and Platform
1. Locate the drawbar assembly; remove and retain
the 1/2-13 x 5 inch hex screw, spring disc washers,
and 1/2 inch hex flanged nyloc nut from the
pivot hub.
2. Align the sulky frame assembly with the drawbar
assembly. Reinstall the 1/2-13 x 5 inch hex screw,
spring disc washers, and 1/2 inch hex flange nyloc
nut, removed in step 1, as shown in Figure 4.
Torque nut to 90 ft-lb (122 N-m).
Figure 4
1.
Drawbar assembly
4.
1/2 inch hex flange nyloc
nut
2.
1/2-13 x 5 inch hex screw
5.
Sulky frame assembly
3.
Spring disc washers
3. Remove the lynch pin and pivot pin from the
mount plate. Align the drawbar assembly with the
mount plate as shown in Figure 5.
Figure 5
1.
Drawbar assembly
3.
Mount plate
2.
Pivot pin
4.
Lynch pin
4. Install the pivot pin through the holes in the
drawbar and mount plate and retain with the
lynch pin.
10
