- 12 -
For 15 & 17 HP Kawasaki engines
:
There is not a “STOP” position. The engine will continue to run when the
throttle control is moved past the rear detent.
Turn the ignition switch to the “off” position to stop the engine.
For B&S Vanguard Engines:
a)
Position the throttle control lever (on console) 1/8" from the upper end of
the slot. Route the throttle cable along the right side of the upper handle,
under the fuel tank support, and position the cable on the
right
side of the
engine between the oil fill tube and engine.
b)
Attach the inner wire to the appropriate throttle control lever on the engine.
Loosen the cable clamp on the engine, place the cable behind it and pullup
on the cable to move the throttle linkage to the
full
throttle
position.
Tighten the cable clamp screw.
3.9
Connect the blade engagement linkages. Loosen jamnut and remove
turnbuckle from lower linkage. Screw turnbuckle onto both upper and lower
linkages simultaneously. (See figure 5) Note that the threads on upper linkage
are left hand. See 5.2.2 for linkage adjustment.
FIG 5
BLADE ENGAGEMENT LINKAGE
3.10 Install and adjust shifter lever.
a)
Remove the 3/8” nyloc nut and spring disc washer from the stud on top of
the transmission. Install the shifter lever through slot in shifter lever plate
and onto the stud on top of transmission. Be sure the square-hole washer
remains between the lever and transmission. Replace the spring disc
washer and nyloc nut(see figure 6). Torque the 3/8” nut to 35ft. lbs.
(47N.M).
b)
Shift lever to second gear and check alignment of lever in slot of shifter
plate. Clearance between top of lever and the top of the slot should be
about equal to the clearance between bottom of the lever and the bottom
of the slot (See figure 7). If it is not, remove lever and bend it slightly to
adjust. DO NOT Bend lever while it is attached to transmission. Reinstall
lever and tighten hardware.
c)
Shift to neutral position. Lever Should not contact the left edged of the
upper slot. Push lever down. Lever should not contact the right edge of
the bottom slot (See Figure 8). Shifter plate can be adjusted side to side
to adjust position of lever relative to the slot in plate. Loosen the two
bolts securing the shifter plate to the shifter lever legs. Adjust shifter
plate and retighten bolts.
For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
Summary of Contents for Metro HP
Page 1: ...i For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
Page 37: ... 32 For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
Page 40: ... 35 NOTES For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
Page 41: ... 36 NOTES For Exmark Mower Parts Call 606 678 9623 or 606 561 4983 www mymowerparts com ...
