Operation
Note:
The foot operated deck lift assist lever
can be used to momentarily lift the deck to clear
objects. Be sure that PTO is disengaged.
8. Torque the 3/8 nyloc nut to 50–55 ft-lb (68-75
N-m).
Figure 18
1.
3/8-16 X 3 3/4 Grade 8
bolt
3.
Front right anti-scalp
bracket shown
2.
Spring disc washer
(cone towards bolt head)
4.
3/8 nyloc-torque to 50-55
ft-lb (68-75 N-m)
Transporting
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary lighting and marking as required by law.
Thoroughly read all of the safety instructions.
Knowing this information could help you, your
family, pets, or bystanders avoid injury.
To transport the machine:
•
Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or truck
with straps, chains, cable, or ropes.
•
Secure a trailer to the towing vehicle with safety
chains.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can
lead to accidents causing personal injury.
Do not drive machine on a public street or
roadway.
Loading the Machine
Use extreme caution when loading or unloading
machines onto a trailer or a truck. Use a full-width
ramp that is wider than the machine for this
procedure. Back up ramps and drive forward down
ramps (Figure 19).
g028043
Figure 19
1.
Back up ramps
2.
Drive forward down
ramps
Important:
Do not use narrow individual ramps
for each side of the machine.
Ensure the ramp is long enough so that the angle with
the ground does not exceed 15 degrees (Figure 20).
On flat ground, this requires a ramp to be at least four
times (4X) as long as the height of the trailer or truck
bed to the ground. A steeper angle may cause mower
components to get caught as the unit moves from the
ramp to the trailer or truck. Steeper angles may also
cause the machine to tip or lose control. If loading on
or near a slope, position the trailer or truck so that it
is on the down side of the slope and the ramp extends
up the slope. This will minimize the ramp angle.
31
