Exmark LAZER Z DS-SERIES Operators, Operator'S Manual

Page: 8 / 60

Safety
Figure 3
1. Safe Zone-Use the mower here on slopes less than 15
degrees
2. Danger Zone-Use a walk behind mower and/or hand
trimmer on slopes greater than 15 degrees, near
drop-offs and water.
3. Water
• Remove or mark obstacles such as rocks, tree
limbs, etc. from the mowing area. Tall grass can
hide obstacles.
• Watch for ditches, holes, rocks, dips and rises that
change the operating angle, as rough terrain could
overturn the machine.
• Avoid sudden starts when mowing uphill because
the mower may tip backwards.
• Be aware that operating on wet grass, across steep
slopes or downhill may cause the mower to lose
traction. Loss of traction to the drive wheels may
result in sliding and a loss of braking and steering.
• Always avoid sudden starting or stopping on a
slope. If tires lose traction, disengage the blades
and proceed slowly off the slope.
• Follow the manufacturer’s recommendations for
wheel weights or counter weights to improve
stability.
• Use extreme care with grass catchers or
attachments. These can change the stability of the
machine and cause loss of control.
Using the Rollover Protection System
(ROPS)
A Rollover Protection System (roll bar) is installed
on the unit.
WARNING
There is no rollover protection when the roll bar
is down. Wheels dropping over edges, ditches,
steep banks, or water can cause rollovers, which
may result in serious injury, death or drowning.
• Keep the roll bar in the raised and locked
position and use seat belt.
• Lower the roll bar only when absolutely
necessary.
• Do Not wear seat belt when the roll bar is
down.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, and electrical wires) before
driving under any objects and Do Not contact
them.
• In the event of a rollover, take the unit to an
Authorized Service Dealer to have the ROPS
inspected.
Maintenance and Storage
• Disengage drives, lower implement, set parking
brake, stop engine and remove key. Wait for all
movement to stop before adjusting, cleaning or
repairing.
• Keep engine and engine area free from
accumulation of grass, leaves, excessive grease
or oil, and other debris which can accumulate
in these areas. These materials can become
combustible and may result in a fire.
• Let engine cool before storing and Do Not store
near flame or any enclosed area where open pilot
lights or heat appliances are present.
• Shut off fuel while storing or transporting. Do
Not store fuel near flames or drain indoors.
• Park machine on level ground. Never allow
untrained personnel to service machine.
• Use jack stands to support components when
required.
• Carefully release pressure from components with
stored energy.
• Disconnect battery before making any repairs.
Disconnect the negative terminal first and the
8