Operation
WARNING
Adjusting the cutting height levers could bring
your hands into contact with a moving blade. A
moving blade can cause serious injury.
•
Stop the engine and wait for all movement to
stop before adjusting the cutting height.
•
Do Not put your fingers under the housing
when adjusting the cutting height.
•
Rear Wheel Adjustment:
1. Pull the wheel height adjustment rod upward
to release the pin from the notch in the
adjustment bracket (Figure 13).
Figure 13
1.
Pull upward
4.
Pin
2.
Wheel height adjustment
rod
5.
Rotate to desired setting
3.
Adjustment bracket
6.
Indicator
2. Apply downward pressure or lift the housing
to rotate the height adjustment bracket. Use
the indicator to determine the desired setting.
3. Release the wheel height adjustment rod to set
the pin securely in the desired notch.
•
Front Wheel Adjustment
1. Pull up on the height adjuster and pull the
front wheel shaft assembly outward as shown
in Figure 14.
Figure 14
1.
Front wheel shaft
assembly
4.
Front quadrant block cut
heights
2.
Pull up
5.
Pull outward
3.
Height adjuster
6.
Shaft groove
2. Insert the front wheel shaft assembly into the
desired cut height setting in the front quadrant
block. Lower the height adjuster into the
groove on the front wheel shaft. Pull and
push the wheel shaft assembly to make sure it
has locked into place.
Using the Grass Bag
•
Installing the Grass Bag
1. Stop the engine and wait for all moving parts
to stop.
2. Open the rear door.
3. Grasp the handle on the bag and set the rear
of the bag frame onto the door hinge bracket
(Figure 15).
19
