EXIT Toys 395238, User Manual

Page: 74 / 124

www.jilong.com SFP7-16-GB
Diagnosis of Problems and Solutions
3UREOHPV
Checking Solutions
T h e m o t o r c a n n o t b e
started normally
3RZHU SOXJ QRW SURSHUO\
inserted
L e a k a g e p r o t e c t i o n
disconnected
M o t o r o v e r h e a t e d o r
overloaded
Causes motor to stop
Make sure the power cord is inserted
i n t o t h e 3 - c o r e g r o u n d e d m e t a l
receptacle.
Reset circuit breaker. If the problem
persists, the power system may be
GHIHFWLYH3RZHURIILPPHGLDWHO\DQG
confer with an expert.
Allow the motor to cool naturally and
start it again.
)LOWHU
Unable to rinse the pool
No sand in the body
Location error of the control
valve
Excessive dirt in water
)LOWHUEDUUHOEORFNHG
Sand filling Refer to sand filling
instructions
The control valve rotates to the filter
position
to prolong the running time
&OHDQWKH¿OWHUEDUUHO
T h e f i l t e r i s u n a b l e t o
discharge water or the water
ÀRZUDWHLVWRRVORZ
There is blockage at the
inlet
There is an air leakage at
the gap of the inlet
Excessive dirt in water
)LOWHUPHGLXPLVEORFNHGE\
impurities
The pool is connected with
a cleaning device
Check and clear away the blockage in
the water pipes
Tighten the nozzle nuts and check the
damaged point of the nozzle and water
height
&OHDQWKH¿OWHUVFUHHQ
Backwash
Disassemble the cleaning device
connected to the pool
)LOWHUIDLOVWRUXQ
Water level is too low
)LOWHUVFUHHQLVEORFNHG
Air leakage from the inlet
pipe
Motor or blade is blocked
Inject water to adjust water level
&OHDQWKH¿OWHUVFUHHQLQWKHSRRO
Tighten the nozzle and check the
damaged point
5HSODFHWKH¿WWLQJV
Water leakage on the control
valve or upper cover The seal ring of the body is
lost or too dirty
The control valve retainer
i s n o t t i g h t l y s e c u r e d
ordamaged Remove the upper cover of the control
valve and sleeve the seal ring of the
body
Clean the seal ring of the body with a
water pipe
Tighten the screw with a screwdriver
5HSODFHWKH¿WWLQJV
The manometer fails to run T h e i n n e r w a l l o f t h e
manometer is blocked
The manometer is damaged
Remove the manometer from the
control valve and clear away the
impurities on the inner wall
5HSODFHWKH¿WWLQJV
Sand enters the pool The sand particles are too
¿QH
Use 20# quartz sand only
3DUWLFOHVL]HRIWKHVDQGLVPP
Or replace the sand