![Exile X1200.1 Manual Download Page 7](http://html1.mh-extra.com/html/exile/x1200-1/x1200-1_manual_2450717007.webp)
© 2007 Exile Car Audio • www.exileaudio.com
Amplifier Manual
Amplifier Owner’s Manual
0/7%2
02/4%#4
).054
,
2
,
2
/54054
-).
-!8
'.$
6
2%-
30%!+%2/54054
0/7%2
/54054-!34%2
'!).
35"3/.)#
,0&
"!33
"//34
).0543,!6%
2%-/4%
D"
D"
INPUT
Connect preamp signal cables from the head unit to these terminals.
OUTPUT
Provides a full range signal for an additional amplifier. There is no signal loss if using this
output.
LPF CROSSOVER FREQUENCY
Controls the lowpass crossover point for the speaker outputs. The crossover is always on
with a 24dB per octave slope. The potentiometers have 41 detents see the chart to set the
exact crossover frequency desired..
OUTPUT MASTER - INPUT SLAVE
See page 10 for details on how to use STRAP technology.
BASS BOOST
Variable bass boost from 0 to 18dB @ 45 Hz.
REMOTE BASS LEVEL CONTROL
This port is for connecting the optional remote level control (XRB1). This allows up to
20dB of volume adjustment. This is not a bass boost, it controls the level of the low pass
signal.
GAIN
Used to reach maximum amplifier power with a wide variety of headunits.
SUBSONIC CROSSOVER FREQUENCY
Controls the highpass crossover point for the speaker outputs to eliminate extreme
low frequencies. The crossover is always on with a 24dB per octave slope. The
potentiometers have 41 detents see the chart to set the exact crossover frequency
desired.
12V+
This must be connected to the fused positive terminal (+12V) of the car’s battery.
REMOTE
This must be connected to sw12V, usually a trigger wire coming from the head
unit or ignition.
GND
This must be connected to the negative terminal of the car’s battery or bolted to a clean,
unpainted part of the chassis of the vehicle.
(Above X2400.1 is shown. X1200.1 has a 4 gauge 12v/GND terminal as found on Page 6.)
SPEAKER OUTPUTS
Used to connect the amplifier to speakers. The two + terminals are wired together internally,
the - terminals are also wired together internally. Minimum speaker cable size is 12 gauge.
Minimum impedance is 1 ohm.
X1200.1 - X2400.1
Monoblock Power Amplifiers
ENG