Exido 243-009, Instruction Manual

Page: 15 / 29

LIST OF COMPONENTS
1. Handle
2. Basket
3. Immersed heating element
4. Outer jacket
5. Filter lid
6. ON/OFF switch
7. Temperature control light
8. Temperature control knob
9. Control box housing
10. Cord storage area
11. Internal bowl
BEFORE FIRST USE
- Remove the lid, basket, handle, controlbox
and the bowl from the outer jacket.
- Clean the lid, basket, handle, bowl and the
outer jacket in hot soapy water and dry
thoroughly.
- Do not immerse the controlbox in any liquid.
DISMANTLING THE DEEP FRYER
- Remove the controlbox from the appliance.
To do this, gently pull the controlbox
upwards.
- Take the bowl with both hands and pull it
up slightly.
ASSEMBLING OF THE DEEP FRYER
- Place the outer jacket on a heat resistant
dry level surface.
- Replace the bowl until it rests on the top
edge of the outer jacket.
- Replace the controlbox. To replace the
controlbox, firmly slide the controlbox down
the two grooves on the back of the outer
jacket. The appliance will only operate when
the control panel is correctly fitted to the
outer jacket.
USING YOUR DEEP FRYER
- We advise that you use liquid oil, which is
recommended for deep fat frying.
- Ensure the appliance is switched off. Slowly
add the oil to the fryer untill the required
level is reached (between the minimum and
the maximum indications)
- Set the temperature control knob to the
temperature you require. Switch on the
appliance the red ON/OFF lamp will switch
on.
- When the oil is heating, the green
thermostatic light will be illuminated. When
the oil reaches the set temperature, the light
will go out. The thermostat will cycle on and
off to indicate when the appliance is heating
the oil and when the desired oil temperature
has been reached.
- For best results, always wait until the
appliance is at the correct temperature
before adding food.
- Place the food to be fried carefully in the
basket. With the handle attached to the
basket, gently lower the basket into the oil.
- For"crispy" result, we recommend using the
fryer without the lid. Be very careful of
spitting hot oil.
- Always switch off the appliance and unplug
from the power supply after use or whilst
unattended.
- Should you accidentally switch ON the
deep fryer without oil or fat or without the
minimum amount of oil required, the deep
fryer will automatically cut-out, to stop the
appliance from overheating.
- If this happens, first switch-off the appliance
and unplug from outlet. Wait until the
elements are cooled down. Pull out the
cord-set, place your finger inside the
storage area and push upwards onto the
small red button marked RESET.
- This will reset the deep fryer. The deep fryer
is now ready to use.
- Should you wish to use solid fat, turn the
temperature knob to its lowest position. Cut
the solid fat into cubes of size 15-20 mm.
Switch on the deep fryer and rotate the
temperature dial until the light comes on.
15
1.
2.
3.
4.
5.
6.
8.
7.
9.
10.
11.
AT-058 IM 03/07/03 14:25 Side 15