2. Installation
2.1 Removing the Belt Clip
a. Pull the Belt Clip latch forward
(away from the FX-117)
b. While pulling the Belt Clip
latch, push up the Belt Clip as
shown in Figure1.
2.2 Installing the Belt Clip
a. Slide the Belt Clip into the
slot as shown in Figure2.
A “click” indicates the Belt
Clip is locked into position.
2.3 Installing the Battery pack
Caution: Observe the proper battery polarity orientation when
installing batteries. Incorrect positioning can damage both the
batteries and the unit.
a. Slide down the Battery Compartment Cover.
b. Install the rechargeable battery pack by following the orientation
as shown in Figure 3 (the arrow is showing and pointing upward.)
c. Replace the Battery Compartment Cover. See Figure 4.
Important
Read these Safety Warnings before you charge the batteries.
When placing the FX-117 in the charger,
use only the power
supplies listed in the user instructions supplied with the FX-117.
Don’t try to recharge non-rechargeable batteries
.
Make sure the battery compartment cover is securely locked in
place
when you are charging the batteries.
Dispose of used batteries safely and in a way that will not harm
the environment-
never try to burn them or put them anywhere, they
could get burnt or punctured.
Don’t leave dead batteries in your FX-117 units.
They might leak if you do.
2.4
Charging the battery pack
a.
Insert the small plug on the end of the mains adaptor into the
Power-in Connection Jack at the back of the desktop charger.
b.
Plug the mains adaptor into a 240V AC, 50Hz main socket with
the switch on the socket set to OFF.
c.
Switch ON the main socket.
The FX-117 must be charged using the mains adaptor provided.
Using any other adaptor will result in non-compliance with
EN60950-1 and will invalidate any approvals & warranty.
Belt Clip latch
Figure 1
Figure 2
Figure 3
Figure 4
