Exhausto VEX4000, Original Instructions Manual

Page: 22 / 52

Installer menu
Store functions Description
Shown only if reg. type
Standard is selected.
Select Heat 1 regulation type
Select Standard if Heat1 is to be regulated as a single
heating surface.
Shown only if reg. type
Splitter is selected.
Select Heat 1 regulation type
Select Splitter if Heat1 is to be regulated as 2 heating
surfaces connected in sequence = Heat1 and Heat12
●
Set exit signal Heat 12 [0-10V/2-10V]
●
Read off current exit signal for Heat 12 [V]
Shown only if reg. type
Splitter is selected.
Set reg. parameters for exit Heat 12
●
Mark to activate the function
●
Set delay for condenser [s]
●
Read off current condenser delay [s]
Shown only if reg. type
Splitter is selected.
Set reg. parameters for exit Heat 12
●
Set min active time for Heat 12
●
Read off current active time for Heat 12
●
Mark for activation of rise/fall time
●
Set min rise/fall time [Sec]
Shown only if reg. type
Splitter is selected.
Set reg. parameters for exit Heat 12
●
Mark to activate hysteresis Heat 1
●
Set hysteresis for relay Heat 1 [%]
Shown only if reg. type
Splitter is selected.
Set reg. parameters for exit Heat 1
●
Mark to deactivate Heat 1
Shown only if reg. type
Copy is selected.
Select Heat 1 regulation type
Select Copy if Heat 1 is to be regulated as 2 heat surfa-
ces connected in parallel.
Set limits for Heat 2
In many cases Heat2 is an electrically heated surface. To
save energy from this heat source, the control system
may be set to automatically reduce use of this heat
source, depending on the deviation from room tempera-
ture or depending on outdoor temperature.
Set limits for Heat 2
●
None - no limits for Heat 2
Shown only for Room
temperature limitation
Room temperature limits
●
Set temperature difference (setpoint/current) [°C]
●
Connection degree per step [%]
●
Read of Temperature (setpoint/current) [°C]
3005263-2015-08-20
Installer level
22/52