EXFO MAX-800 Series, User Manual

Page: 300 / 495

Test Results
292
MAX-800 Series
Summary (EtherSAM)
Committed

Frame Loss Rate
indicates the rate of frames that are lost. The
reported value is the maximum rate of Frame Loss from all burst
sequences and ramp steps excluding the
CIR+EIR
,
EBS
, and
Traffic Policing steps. Frame Loss is displayed as a percentage
value when the remote unit does not support exponential notation.

Max. Jitter (ms) indicates the maximum measured delay
variation.

Max Latency (ms) indicates the maximum measured round-trip
latency (delay). For Dual Test Set the local to remote and remote to
local values are reported for One-Way Latency Measurement Mode
while a single round-trip value is reported for Round-Trip Latency
Measurement Mode (see
Global Options on page 102).

Avg RX Rate
, for
Service Performance Test
, indicates the
measured average utilization throughput.
Excess
Max RX Rate , for Service Configuration Test , indicates the
measured maximum utilization throughput.

VLAN Preservation indicates if any VLAN mismatch occurred during
any step of a Ramp or Burst tests as follows:
Grey: Undefined
Green: No Mismatch detected
Red: Mismatch detected