EXFO MAX-800 Series, User Manual

Page: 281 / 495

Test Results
MaxTester
273
Service Configuration - Burst
Service Configuration - Burst
From the
Test
menu, tap
Results
,
Service Configuration
, and the
Burst
tab.
Service Name and Selection
Service Name indicates the name of the selected service.
Select the service to be displayed by either using the left/right arrow or by
tapping over the service numbers area then tapping on a specific service
number. An orange background indicates the selected service while a
green background indicates the services that are enabled.
Committed/Excess

Committed - Burst test is the CBS subtest.

Excess
-
Burst test
is the
EBS
subtest.

Direction , available with Dual Test Set or Dual Port topology,
indicates respectively results for local (
L
) and remote (
R
) directions, or
for both port directions.

Burst Size
indicates the size in bytes of the burst used for each subtest.

SLA Verified indicates the committed SLA parameters that are used to
declare the pass/fail verdict. See
Summary (EtherSAM)
on page 290 for
more information on Frame Loss , Max Jitter , Round-Trip Latency ,
Max Latency
, and
Max RX Rate
.

Informational parameters are for information purpose only, they are
not included in the test pass/fail verdict. See
Summary (EtherSAM)
on
page 290 for more information on Frame Loss Rate , Max Jitter ,
Max Latency
, and
Round-Trip Latency
.

Average RX Rate indicates the measured average utilization
throughput for the CBS subtest.