EXFO FTB-860, User Manual

Page: 49 / 409

EtherSAM Test Setup and Results
NetBlazer
37
Configuring an EtherSAM Test
Configuring an EtherSAM Test
To configure the EtherSAM test:
1.
From the
Test
menu, press
Setup
.
2. From the Test Applications tab, under Ethernet group, press
EtherSAM
.
3.
From the Interface tab, configure the Port , Network settings, and view
the information on the
SFP/SFP+
page. See
Interface
on page 280.
Ensure that the link is up in the status bar before proceeding to the next
step.
4.
Press the Global tab and configure the global settings. See Global
Configuration on page 41.
5.
From the Global tab, leave the Dual Test Set check box cleared. To
create an EtherSAM DTS, see
To configure the EtherSAM Dual Test Set
(DTS) test: on page 39.
6. Press the
Services
tab and from the
Service Profile
tab setup each
service. See Configuring Services on page 44.
7. From the Services tab, press the MAC/IP/UDP tab. Configure the
stream settings. See MAC/IP/UDP Configuration on page 302.
8. From the
Services
tab, press
VLAN
and configure the VLAN settings.
See VLAN on page 319.
9. Press the
Ramp
tab. Configure the ramp settings. See
Ramp
Configuration on page 52.