EXCURSION SHX SERIES, Owner'S Manual

Page: 5 / 12

4
G.) Unless you are replacing exis ng speakers of same size, moun ng loca ons
will have to be cut into the doors, body panels or rear deck. In some cases
speaker moun ng holes will be precut in the doors, bodypanels, or rear
deck steel. Due to their structural integrity and accessibility. These precut
moun ng holes should be used whenever possible.
IMPORTANT: Never cut any metal that is an integral part of an automobile`s
safety or structural support system.
NOTE: EXCURSION strongly recommends that you operate the complete
audio system at low volume before final installa on of your SX Series
Automo ve Loudspeakers. This will allow a trial listening test before
securing the loudspeakers into their moun ng loca ons.
Make sure that all speaker wiring is fully protected from cu ng CAUTION:
or wear. Any short circuits developing as a result could severaley damage
the radio unit or amplifier. Make sure that all speaker wires easily reach the
speaker terminals without stress on the wire or connectors.
PREPARING FOR INSTALLATION
Note: The tools listed below may be required for proper installa on.
* An elec ric drill with drill bits
* Phillips-head and standard screwdrivers
* Crimping tool and needle-nose pliers
* Silicon sealant or closed cell weather-stripping
* Metal file, Hole saw, Tin Snips, Wire strippers
INSTALLATION PRECAUTIONS
Note: Proceed only if you are a qualified installer otherwise let your dealer do it.
* Always wear protec ve eyewear when using tools
* Turn OFF all stereo and other electrical devices before you begin
* Disconenect the (-) nega ve lead from your vehicle`s ba ery.
* Keep the speakers in the package un l final installa on.
* Locate fuel lines, brake lines, oil lines, electrical cables when planning installa on.
* Check to see clearance behind the moun ng surface before installing speakers.
* When running speaker wires through sheet metal, be sure to use gromments
to properly insualte the wires from metal edges.